Product Manual

3. Advance the end of the roll past the roller so that it extends past the printer door, as
shown.
4. With one hand, pull lightly on the paper to take up any slack. With the other hand,
close the printer door by pushing it down and into place until it clicks.
Be certain that the paper does not catch in the printer door.
Connect AC power
You can use the monitor with AC or battery power (after fully charging the battery).
WARNING Shock hazard. Inspect the AC cord for exposed copper before
touching the cord.
CAUTION During continuous monitoring, keep the monitor connected to
AC power at all times. If only battery power is available, you must remain in
the room with any patient whose vital signs are being monitored
continuously. Actively monitor both patient and battery status to ensure
patient safety.
1. Insert the power cord into the AC power connector port on the back of the monitor.
Directions for use Setup 29