assembly instructions

Techn. Änderungen vorbehalten! 10  Copyright weka-Holzbau GmbH, Neubrandenburg
expansion zone. The cover battens attached to the door frame (under no circumstances to the wall boards)
ensure a clean transition from door frame to the wall boards.
The roofing felt provided serves primarily as a temporary protection against the weather. We recommend
that you also apply a further layer of roof paper with bitumen cold bonding agent. (Not included in the
delivery!)
The possibility of differing wood moisture + tolerances in individual components may lead to variations in
dimensions, particularly in the area of the pediment/side wall height,
which must be adjusted during installation using appropriate means (e.g. electric plane).
The window/door panes must be sealed all round with transparent silicone for windows immediately after
assembly and painting to ensure full resistance to driving rain.
Otherwise extreme rainfall may lead to interior leaks which cause discoloration and damage to the wood.
The manufacturer will accept no liability for such damage, there will be no replacement within the scope of
the guarantee nor is it covered by the manufacturer’s warranty. We therefore refer you again to our
guarantee conditions at this point.
Tools
You should have the following tools to hand before beginning assembly:
Tape measure Drill Electric screwdriver Hammer Pencil Burring iron Rubber mallet
Saw Universal cutter Cord Spirit level Spanner
Abbreviations
RW = Rear wall
mm = Millimetre
= Not included in delivery!
We hope you have a successful installation and wish you many happy hours enjoying your
weka product.