Assembly instructions for supplementary kit

Techn. Änderungen vorbehalten! 3 © Copyright weka-Holzbau GmbH, Neubrandenburg
- GB -
Dear customer
Thank you very much for choosing a weka product.
Read these instructions through completely before assembling your product in order to avoid errors in
assembly or damage.
Item no.: 500.1501.00.00 may be fitted in all weka saunas with the following dimensions:
- Interior sauna width: 179 cm (approx. 190 cm external dimension)
- Interior sauna depth 162 – 229 cm (approx. 175 – 244 cm external dimension)
IMPORTANTPlease use the enclosed packing list to check immediately that your weka product has
been
delivered complete and intact.
Please do not dispose of the packing list before the guarantee period has expired. This list enables you to
check that all the individual parts are present. It should be retained along with the proof of purchase. Any
complaints which may arise can probably be easily rectified with this list. The item numbers on the packing
list do not correspond to the item numbers in the following assembly instructions.
We recommend that 2 people carry out the assembly.
In order to prevent accidents, we recommend that children are kept out of the direct vicinity during assembly.
We reserve the right to make further technological developments. This means that there many be minor
deviations in the illustrations.Please do not simply throw away the packaging material. Paper, card and
corrugated board as well as plastic packaging materials should be placed in the correct collection containers.
Special information
The wall elements comprise carefully selected Nordic spruce, with the interior panelling constructed from a
special wood with low heat conductivity. Healthy knots, light discoloration and small cracks are characteristic
of the wood, lending the cabin its natural appearance. They are therefore not grounds for complaint.
The best location for your cabin would be a dry, well ventilated room.A stone or tiled floor is both a practical
and an attractive floor covering.
The outlet opening is located in panel 3 of the cabin. This must always be positioned diagonally to
the inlet opening in the front wall.
The outlet opening in the rear wall of the sauna cabin is to be opened before assembling this kit
Should the sauna have a depth of 162 cm (interior dimension), the slatted floor of the sauna must be
shortened by approx. 4 cm.
Care
The wall boarding inside may not be covered or allowed to come into contact with moisture.
Ventilate the cabin well after every use. Also take care to ensure the room in which the cabin is situated is
also well ventilated. The wood in the interior of the cabin is maintenance
free. It may not be covered or
come into contact with moisture. Stubborn stains on the wood can be removed with sandpaper.
If the cabin is not to be used for a long period of time, we recommend that the door is kept open.
Always use wood glue, never chemical adhesives, inside the sauna. We do not recommend that you treat
the surfaces
.