Datasheet

Version 001
15
IdeaWerk Plus User Manual
4.3.8.9 In order to make the model better fixed on the build plate, it is
recommended to first print the bottom and then print the model on the
bottom.
Notice: without the bottom printed, only smaller models can be
printed, the platform shall be well adjusted and a layer of textured paper
needs to be pasted.
4.3.8.10 Some models require support to complete printing, including
external support and overall support. External support refers to additional
printing part added to support the overhanging part on the surface of the
model. As shown below, the external support is needed between the
animal’s chin and the platform.
4.3.8.11 Overall support refers to both internal and external support of
the model.
4.3.8.12 Structure of internal and external support of the model
4.3.8.13 In print parameter settings, check Exterior support and Full
support, as shown below.
4.3.8.14 If some parameters are modified, but you want to use the original
parameters, you can click “Reset” to restore the default settings, as shown
below.
4.3.8.15 Set the print height: directly input Z-axis height in the dialog and
External support
Internal support