Datasheet

Version 001
14
IdeaWerk Plus User Manual
4.3.8.3 Model density refers to the filling density of the model, set by
percentage. Click “▼” to select different densities. (The default is medium
30%)
4.3.8.4 Different filling densities will affect the printing time. In the same
model, the greater the density, the longer the duration of the printing, the
more solid the model. Please select different density according to the
actual needs as shown below.
4.3.8.5 Layer thickness refers to the height of each layer of the model.
Click “▼” to select 0.2 or 0.3mm, and the default is 0.2mm. The print time
at the parameter of 0.3 will be shorter than 0.2, but the model’s surface is
less accurate.
4.3.8.6 Case layers refer to the thickness of the model surface. Click “▼”to
select different wall thickness, “Thin, Normal or Thick”.
4.3.8.7 If the model is a cube, with the same filling (10%), the thickness of
the red frame represents different effect of “Thin, Normal or Thick”, as
shown below.
Thin Normal Thick
4.3.8.8 Speed means the movement speed of the model during the
printing and the speed of the extruder. With different printing speeds, the
model consumes different time. The higher the speed, the shorter the
duration, the less accurate the model surface. Please select according to
the actual situation. Click “▼” to select different speeds “slow, standard or
fast”.
10%
30%
50%
90%