Datasheet

Version 001
10
IdeaWerk Plus User Manual
4.2.9 In the pop-up interface, click “Finish” to complete the driver
installation.
4.2.10 Click “Finish” to complete the entire software installation.
4.3 Interface and function
4.3.1 Turn on the power switch, and double click “DoraWare-P” on the
desktop to open software.
4.3.2 In the software interface, the bar “1” at the top left corner is the
function menu. Move the mouse to the menu icon, and corresponding
functional description will be displayed; the bar “2” at the lower left
corner is schematic three-dimensional coordinates; the middle bar “3” is
model display area, and the side with red lines faces the operator; the
bottom bar “4” is for status display, indicating the temperature and model
information.
4.3.3 Import model
4.3.3.1 Click the icon “Load”, and the dialog pops out to look up the
model path. After selecting the model, click “Open”. The model with
imported software is as shown in Figure 4.3.2.
Notice: if you want to open a previously generated GCODE file, you
need to store the STL file and the GCODE file in the same folder. Import
the STL file to open the GCODE file, without a new GCODE.
4.3.3.2 Click “Load” again, and you can import multiple models.
Notice: no more than the platform area, otherwise the models printed
may overlap.
4.3.4 Generate a file
4.3.4.1 Click the icon “Export”, and the dialog box to save the file path
pops out. Select the save path and click “Save”, and software
automatically generates the printing from USB flash disk file.
4.3.4.2 Notice: do not modify its suffix format when you save an
offline file, otherwise the IdeaWerk Plus will not recognize the file.