Datasheet

Version 001
7
IdeaWerk Plus User Manual
3.2 Print from USB flash disk
Take the model “CUBE” for example to illustrate the process of printing
from USB flash disk.
3.2.1 Turn on the power switch, reset the IdeaWerk Plus and click to enter
the user interface. Insert the USB flash drive into the IdeaWerk Plus, and
the interface is shown as follows.
3.2.2 Click the file display frame to enter the model selection interface,
and click “/3DMODEL/CUBE.WTK” to select the model “CUBE”, as shown
below.
3.2.3 Enter the interface “Print” and click “START” to heat the extruder and
the platform. PLA material is used in this model, so the extruder
temperature is set at 220 °C and the platform temperature is set at 30 °C.
3.2.4 After the platform and the extruder are heated to the target
temperature, the IdeaWerk Plus starts printing.
3.2.5 The printing is in progress, 82% completed, as shown in the
interface below. Notice: since the progress is displayed by 1%, if the
model is large, the change of the progress bar may be seen after the
printing proceeds for a long time, and if the model is small, it is possible
to see the progress skipping by 1%.
3.2.6 After the model printing is completed, the object is as shown in the
following figure.
3.2.7 Click “OK” to complete the printing.
3.2.8 Remove the four clamps, and take down the model with a shovel.
Notice: wear gloves when removing the model to prevent burn by the
hot platform!
3.2.9 After removing the model, fix the hotbed panel again with four
clamps on the build plate.
25
25
0
0
/3DMODEL/ICE CREAM.WTK
/3DMODEL/WHISTLE.WTK
/3DMODEL/CUBE.WTK
/3DMODEL/FEED RACK.WTK
/3DMODEL/CARDCASE.WTK
6
87
30
30
/3DMODEL/CUBE.WTK
220
220
30
30
/3DMODEL/CUBE.WTK
220
220
30
30
/3DMODEL/CUBE.WTK
220
°C