Manual

5
8.Mountthelevers.
a Checkboththeinteriorandthe
exteriorassemblies,tomakesure
thesetscrewislocatedontheoppositeside,
(thesidefurthestawayfromthelatchbolt).
Ifcorrectlypositionedproceedtostepc,ifitisnot
ontheproperside,removeandswitchtheset
screwasdirectedinthefollowingstep-stepb.
b. Usingtoolprovided,removesetscrewby
unscrewingitinaclockwisedirection(thisis
thereversedirectionofwhatmightfeelnormal).
Repositionsetscrewtotheothersideandscrew
itinfully,usingacounterclockdirection
(againthisisthereverseofthenormal
direction).
c.
Installinterior
leverandtighten
setscrew
clockwise.
e.Insertthekeyintocylinder
androtate itclockwiseto
thehorizontalposition,then
presslevertoseat into
assembly.Withkeystill in the
horizontalposition,tightenthe
setscrewclockwisetosecurethelever.
SetScrew
(onoppositeside)
LatchBolt
d.Toinstallexteriorlever,rst
removethekeyfromcylinderand
insertthecylinderintothelever
shaft,makingsurethesleeveof
cylinderispositionednearkeyway.
Note that the cylinder will not seat
back fully at this time.Slidethe
leveronsmoothly,aligningribs
insidetheleverwiththelevershaft
(leverwillnotseatallthewayuntil
completingstepe).
Cylinder
Sleeve
Shaft
Continued