Install Instructions

Part number 550-100-260/0520
86
ECO
®
Tec GAS-FIRED WATER BOILER – 80/110/150/199 BOILER MANUAL
HOMEOWNER NAVIGATION menus
"OILER -ODEL !LTITUDE AND &UEL4YPE ARE
CRITICAL SETTINGS
Failure to set correctly could
result in severe personal injury, death or substantial
property damage.
1. Access contractor menus by pressing and holding the WM
Logo for 7 seconds from the home screen.
2. See the following pages for explanations of control setting
options.
-%.5)TEM 0520/3%
HOMEOWNER
SCREEN
s Banner info
s Status image
s Fault name and reset button
s Time/Date
s Navigation buttons – 2 dots and Home
s Current temperature
s Target Temperature (when a priority is active)
BOILER
SETTINGS
s Status: Shows the current sequence of operation status with
the active priority.
s Input Status: Shows the current status of each call for heat.
s 0-10v: Shows the current 0-10v input value from external
device.
s 1-4: Shows inputs 1 through 4, what they are assigned to,
their custom names and their status. Input 4 will not show
for Combi models.
s Pumps/Aux: Shows which aux/pump outputs are currently
active.
s Additional Heat Demand: Shows whether AHD is off or on.
Only appears if a priority is selected to use AHD.
s DHW Flow: Shows the current flow rate of the Combi DHW
in GPM. Only visible for Combi models.
s DHW Temp: Shows the current temperature of the Combi
DHW sensor. Only visible for Combi models.
s Outdoor Temp: Shows the current outdoor temperature sen-
sor value. Only visible if selected to use.
s Supply/Return: Shows the current System Supply and System
Return temperature. Only visible if selected to use.
s Boiler Out/In: Shows the current Boiler Out and Boiler In
temperatures.
s Target Temp: Shows the current Target Temperature of the
active priority.
s Mod Rate: Shows the modulation rate of the boiler’s blower
motor.
DATE/TIME
BUTTON
s Allows user to edit the current date and time.
BACKLIGHT
s Allows user to edit how bright the screen is during normal
operation and when dormant.
CLEAN
s Locks the screen so nothing can be pressed for 10 seconds
while the user cleans the screen.
SOFTWARE
s Displays the current software revisions of the control and
display.
HOT WATER
s Allows the user to edit the Hot Water Temp of the Combi
demand, as well as enable or disable PREHEAT mode or
ECO BOOST.
MAINTENANCE
INFO
s Allows the user to view contractor and maintenance informa-
tion, as well as reset the maintenance reminder when present.
SETTINGS
s Allows the user to edit temperature units, screen timeout,
daylight savings time and sound effect of presses.
3CREENSSHOWNABOVEARETYPICALONLY
!CTUALSCREENSDEPENDONCONTROL
SETTINGSCHOSEN