Install Instructions

Part number 550-100-131/0715
– 70 –
™
GAS-FIRED WATER BOILER — Boiler Manual
EXPRESS SETUP — EXAMPLE C
-ULTIZONESPACE HEATING:ONEVALVES7-:6CONTROLLER\DHW
(Direct-piped)

EVG CONTROL SETTINGS
(IN ORDER OF WIZARD SEQUENCES)
RED —
VALUE MUST BE SET OR VERIFIED
D — DEFAULT ACCEPTABLE; CHANGE ONLY IF
DESIRED
BOILER SETTINGS
"/),%2-/$%,
6ERIFYMODELNUMBERISCORRECT
773$4%-0
$EFAULT&ORASREQUIRED
()'(!,4)45$%
3ETTOALTITUDEIFOVERFEET
INPUT/OUTPUT 1 (Assign to PRIORITY 1)
7(!4)34(%53%/&).054/54054
(%!4$(7$%-!.$
7(!402)/2)49)3).054
select 02)/2)49
7(!43934%-490%)3).054/54054
$(7(D)
4!2'%4-/$3%.3/2
"/),%2/54(D)
4!2'%4!$*534
./.%(D)
3500,9-!8
$(or change if desired)
25."/),%205-0
./(D)
25.!5805-0/54054
$(not applicable)
INPUT/OUTPUT 2 (Assign to PRIORITY 2)
7(!4)34(%53%/&).054/54054
(%!4$(7$%-!.$
7(!402)/2)49)3).054
02)/2)49
7(!43934%-490%)3).054/54054
3ELECTCORRECTSYSTEMTYPE
4!2'%4-/$3%.3/2
3934%-3500,9(D)
4!2'%4!$*534
/$4(D)
(outdoor sensor must be installed)
3500,9-!8
$(or change if desired)
3500,9-).
$(or change if desired)
/$2%3%4-!8
$(or change if desired)
/$2%3%4-).
$(or change if desired)
"//344)-%
$(or change if desired)
25."/),%205-0
9%3(D)
25.!5805-0/54054
$(not applicable)
INPUT/OUTPUT 3 (Not used)
7(!4)34(%53%/&).054/54054
./.%
PRIORITY SWITCH TIMES:
0-!8/.4)-%
$(or change if desired)
0-!8/.4)-%
$(or change if desired)
0-)./.4)-%
$(or change if desired)
0-)./.4)-%
$(not applicable)
Finish the WIZARD
%.4%24)-%$!4%!.$-!).4%.!.#%).&/2-!4)/.!302/-04%$
"OILER -ODEL!LTITUDE AND &UEL4YPE ARE CRITICAL
SETTINGS
Failure to set correctly could result in severe
personal injury, death or substantial property damage.
Incorrect setup or piping can result in severe personal
injury, death or substantial property damage.
Use primary/secondary piping or equivalent ONLY. $O
NOTUSEDIRECTCONNECTSYSTEMPIPING
Verify that the correct system type is selected on the con-
trol and that operating temperature settings are suitable
for the system. System and structural damage can occur
if temperatures are too high.
Purpose
s Space heating with multiple zones.
s Zoning with zone valves.
$/ ./4 use 3-wire zone
valves — the voltage on the valve end switch will dam-
age the EVG control. Use only 4-wire zone valves with
isolated end switches.
s DHW piped directly to the boiler.
s DHW priority — space heating is disabled during call
for heat from water heater.
Control setting notes
s See the table at right for required and optional settings.
s The sequence in the table follows the WIZARD.
s If not using the WIZARD, follow instructions elsewhere
in this manual to enter the settings manually.
s The system circulator is wired to OUTPUT 2. It will
be activated on any call for heat from a zone valve end
switch.
Circulators and piping
Provide an external relay and external power
to any circulator if its load rating exceeds 2.2
amps FLA, 3.6 amps locked rotor, or 16.4 amps
in rush.
s Piping must be primary/secondary as shown.
s DHW circulator must be selected to handle the pressure
drop through the boiler, water heater and piping. DHW
circulator supplied by installer.
s For some large indirect water heaters, the required flow
rate may require piping the water heater differently.
s The control settings in table at right provide DHW
priority — space heating will be discontinued during
a call for DHW.
s Zone valves and system circulator supplied by installer.
For alternate zone wiring using a zone controller, see
page 59.
s A by-pass pressure regulator is recommended when
used in a zone valve system as shown in this express
setup.
"/),%2
s Boiler circulator shipped loose with boiler.
s Follow all instructions in this manual for piping boiler
and system.
.OTE )F$(7ISNOTUSED, set the USE of INPUT/OUTPUT 1
to NONE. Keep all other wiring as shown at right and
follow all settings given above for PRIORITY 2.