User Guide

GOLD CGt Gas-Fired Water Boiler User’s Information Manual
10
Part Number 550-110-291/0709
Operating instructions
FOR YOUR SAFETY READ BEFORE OPERATING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO THE APPLIANCE
• Donottrytolightanyappliance.
• Donottouchany electric switch;donotuse
any phone in your building.
• Immediatelycallyourgassupplierfromaneighbor’sphone.
Follow the gas supplier’s instructions.
• Ifyoucannot reach yourgassupplier,calltheredepart-
WHAT TO DO IF YOU SMELL GAS
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights
the burner. Do not try to light the burner by
hand.
B. Before OPERATING, smell all around the
appliance area for gas. Be sure to smell next to the
oorbecausesomegasisheavierthanairandwill
settleontheoor.Seebelow.
C. Useonlyyourhandtoturnthegascontrolknob.Neveruse
tools. If the knob will not turn by hand, don’t try to repair it,
call a qualified service technician. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control, which has been under water.
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
1.
STOP! Read the safety information above on this label.
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. Remove jacket front panel.
5. This appliance is equipped with an ignition device which automatically lights the burner.
Do not try to light the burner by hand.
6. Turn Gas control knob clockwise to OFF.
7. Waitve(5)minutestoclearoutanygas.Thensmellforgas,includingneartheoor.
If you smell gas, STOP! Follow “B” in the safety information above. If you don’t smell
gas, go to the next step.
8. Turn Gas control knob counterclockwise to ON.
9. Turn on all electric power to the appliance.
10. Set thermostat to desired setting.
11. If the appliance will not operate, follow the instructions “TO TURN OFF GAS TO AP-
PLIANCE
” below and call your service technician or gas supplier.
12. Replace jacket front panel.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to
be performed.
• Gas valve — Honeywell VR8204 and White-Rodgers 36E
3. Remove jacket front panel.
4. Turn Gas control knob clockwise to OFF. Do not
force.
5. Replace jacket front panel.