Manual

Use the Security Lock Provided with your Revolver

This revolver comes with a security lock to assist in

protecting against unauthorized use. See Figure 1.

The revolver must be unloaded when the security lock

is in place on the revolver. WARNING: Using the

security lock cannot substitute for securing your firearm

and ammunition in separate, locked locations.

Use either of the following two methods to install the

security lock provided with your Small Bore:

Method 1

1) Remove the provided security lock and block from

its package. See Figure 1.

2) Install the block on the

trigger (see Figure 2)

and then install the

security lock on the

security block. See

Figure 3. Next, close

the security lock. See

Figure 4.

Method 2

1) Looking at the trigger guard there is a hole in the

center bottom. See Figure 5.

2) Insert the lock through the hole and close the lock.

See Figures 6 and 7 .

W A R N I N G

Always store the key to the

security lock: (1) in a separate

location away from the

revolver; (2) in a secure

location unknown and not

accessible to others,

especially children. Whether

you secure your firearms by using the supplied security lock, a gun lock or safe

or some other mechanism, it is YOUR RESPONSIBILITY to store your firearms

in such a manner that children and other unauthorized persons cannot gain access

to them.

Figure 2

Figure 3 Figure 4

Figure 5

Figure 6

Figure 7

Figure 1