Manual

injury. Those who clean firearms should take protective measures to avoid contact

or exposure to such chemicals.

D) Using the bore brush with powder solvent, scrub the interior of the barrels and

chambers to remove any powder and lead residue in the bore. Always and

lastly, swab the interior of the barrels with cotton patch with gun oil to coat

and protect the bore and chambers from rust and corrosion.

E) Any powder fouling on the firing wall, barrel, etc. can be easily cleaned with a

brush and powder solvent.

F) All external surfaces should be wiped down with a light coat of rust preventative.

Avoid using too much oil as powder, dust or other foreign material may get

trapped in the oil. This could lead to congealed deposits which may interfere

with the safe and reliable operation of the revolver.

G) USE CAUTION while using solvents in gun bore cleaning. Prolonged or

excess contact with solvents can damage the gun’s bluing and finish. Be

sure to wipe away all excess solvent and then lubricate with oil.

H) A gun should be cleaned after firing. In addition, external parts should be

wiped with an oiled cloth after handling. A light oil is ordinarily all that is

necessary in cleaning if the gun has not been fired or fired very little. If a gun

is used frequently, it must be cleaned after each firing and regularly serviced

by a professional gunsmith. If the gun has been stored, remove all excess oil

and/or grease before firing. Always check to be sure that no cleaning patch

or other obstruction remains in the bore or chambers before firing.

DANGER – AMMUNITION WARNING

Firearms may be damaged and serious personal injury or death to the shooter or

bystanders may result from any condition which contributes to the generation of

excessive pressure or uncontrolled release of gas within the firearm. Such adverse

conditions can be caused by bore or chamber obstruction, propellant powder

overloads or by defective, incorrect or improperly loaded and assembled cartridge

components. Even the strongest firearm can be blown up as a result of excessive

pressure. It is extremely dangerous to use a cartridge whose pressure is greater

than that developed by cartridges loaded to industry standards.

AMMUNITION (CARTRIDGES) NOTICE

We specifically disclaim responsibility for any damage, personal injury or death

occurring in connection with or as the result of the use of European American

Armory Corp. revolvers with faulty, nonstandard, remanufactured, Super-Vel, +P,

hand-loaded or reloaded ammunition, used cartridges or cartridges other than

factory cartridges for which the firearm was originally chambered.