Manual

14
TO UNLOAD AND/OR EXTRACT EMPTY
CASES:
1) Use both hands during unloading so the revolver
and ammunition cartridges empty cases do not
fall. See Figure 23.
W A R N I N G !
Keep your fingers out of the trigger guard and off the
trigger.
W A R N I N G !
Always make sure the revolver is pointed in a safe
direction during any hammer or trigger movement.
2) Point the barrel down and keep the revolver pointed
in a safe direction. See Figure 24.
3) Move the hammer to the second notch. See
Figure 25. Move the cylinder gate aside. Press
the ejector rod, which enters the chamber and
expels the cartridge or cartridge case.
4) Let the ejector thumb piece come back. Locate
the next chamber before it and repeat the
procedure. See Figure 26a and 26b.
5) Before closing the cylinder gate, make sure that
the cylinder is totally empty or unloaded by
causing it to perform a full revolution.
6) If once you have extracted the empty cases or
unloaded the revolver and you do not wish to reload
the revolver, close the cylinder loading gate and
pull the hammer all the way back with a smooth
stroke. Then controlling the hammer very carefully
with your thumb, squeeze the trigger and let the
hammer down to the rest position. The rest position
is when the hammer is against the frame. In this
position, the trigger is fully forward and the transfer
bar is out of the firing position.
Figure 25
Figure 26a
Figure 26b
Figure 24
Figure 23