Manual

inserted when the release pops out to its locked position.

MANUFACTURER’S WARNING:

This firearm was manufactured to properly perform with the original parts as

designed. It is your duty to make sure any parts you buy are correctly installed

and that neither replacements nor originals are altered or changed. Your gun is a

complex tool with many parts that must relate correctly to other parts for safe

and accurate operation. Putting a gun together wrong or with modified parts can

result in a damaged gun, or personal injury or death to you or others. Always let

a qualified gunsmith work on your gun or at least, check any work not performed

by a gunsmith. Firearm safety is your primary concern. THE GUN OWNER MUST

ACCEPT FULL RESPONSIBILITY FOR THE CORRECT REASSEMBLY AND

FUNCTIONING OF THE FIREARM AFTER ANY DISASSEMBLY OR

REPLACEMENT OF PARTS.

TO CLEAN AND MAINTAIN YOUR REVOLVER:

A) Follow procedures for unloading revolver as described previously.

B) Remove the cylinder from the revolver as described previously.

C) Materials needed to clean this revolver are: a cleaning rod, cotton bore

patches, brass bore brush, powder solvent, a small soft brush and good

quality gun oil.

WARNING: Lead or lead compounds are known to the State of California to

cause cancer, birth defects, reproductive toxicity, and other serious physical

injury. Those who clean firearms should take protective measures to avoid contact

or exposure to such chemicals.

D) Using the bore brush with powder solvent, scrub the interior of the barrels and

chambers to remove any powder and lead residue in the bore. Always and

lastly, swab the interior of the barrels with cotton patch with gun oil to coat

and protect the bore and chambers from rust and corrosion.

E) Any powder fouling on the firing wall, barrel, etc. can be easily cleaned with

a brush and powder solvent.

F) All external surfaces should be wiped down with a light coat of rust preventative.

Avoid using too much oil as powder, dust or other foreign material may get

trapped in the oil. This could lead to congealed deposits which may interfere

with the safe and reliable operation of the revolver.

G) USE CAUTION while using solvents in gun bore cleaning. Prolonged or excess

contact with solvents can damage the gun’s bluing and finish. Be sure to

wipe away all excess solvent and then lubricate with oil.