User manual

WI-MOD-9-E Wireless Ethernet User Manual
WI-MOD-9-E Manual V1.9 Page 58
• Adjust PC network settings
Set Configuration PC network card with network setting of IP address 192.168.0.1, subnet
mask 255.255.255.0
• Open configuration webpage with Internet Explorer at address http://192.168.0.1XX/
When prompted for password, enter default username “user” and password “user”
Enter “Quick Start”, and select Access Point.
Change the IP address to 192.168.0.200
Enter a System Generator String
Select the Radio Encryption required.
Set dipswitch to RUN.
Save the changes, and unit will reset. Wait for unit to complete reset.
• Open configuration webpage with Internet Explorer at address http://192.168.0.200/
Select Network settings menu option
When prompted for password, enter default username “user” and password “user”
Device Mode should be set to Router.
Set the Gateway IP address to 192.168.0.1
Set the Ethernet IP address to 192.168.0.200, network mask 255.255.255.0
Set the Wireless IP address to 169.254.102.54, network mask 255.255.255.0
Click on button Save to Flash and Reset. Webpage will display that message indicating
details are being written to flash. Wait for WI-MOD-9-E to reboot before removing power.
Client Configuration
Perform the same configuration steps as the Access Point configuration with the following
differences:
• Connect straight through Ethernet cable between PC and WI-MOD-9-E.
• Ensure configuration PC and WI-MOD-9-E are setup to communicate on the same network
• Set dipswitch to SETUP
• Power up unit, and wait for LINK led to cease flashing.
• Adjust PC network settings
Set Configuration PC network card with network setting of IP address 192.168.0.1, subnet
mask 255.255.255.0
• Open configuration webpage with Internet Explorer at address http://192.168.0.1XX/
When prompted for password, enter default username “user” and password “user”
Enter “Quick Start”, and select Client.