User manual

Chapter Three Operation
Page 57 March 2010
Client 1 Configuration
Perform the same configuration steps as the Access Point configuration with the following
differences:
• set IP address of WI-MOD-9-E to 192.168.0.201
• set the Operating Mode to Client.
Ensure the same System Generator String is used and the same Radio Encryption method is
selected.
Client 2 Configuration
• As above, but use IP address 192.168.0.202
Connecting two separate networks together
Network A Configuration
In this example, network A is connected to the internet via a router at IP address 192.168.0.1.
Devices on Network A that only require access to devices on Networks A and B, should have
their gateway IP address set to the WI-MOD-9-E Access Point as 192.168.0.200.
Devices on Network A, that must interact with devices on Networks A and B and the internet
should set the internet router 192.168.0.1 as their gateway, and must have a routing rule
established for devices on Network B. On PCs, this may be achieved with the MS-DOS
command ROUTE. For this example use: ROUTE ADD 192.168.102.0 MASK 255.255.255.0
192.168.0.200
Network B Configuration
All devices on Network B should be configured so their gateway IP address is that of the WI-
MOD-9-E Access Point as 192.168.102.54
Access Point Configuration
• Connect straight through Ethernet cable between PC and WI-MOD-9-E.
• Ensure configuration PC and WI-MOD-9-E are setup to communicate on the same network
• Set dipswitch to SETUP
• Power up unit, and wait for LINK led to cease flashing.
LAN A
Internet
Client
Bridge
Access Point
Router
192.168.0.0
255.255.255.0
169.254.102.54
LAN B
169.254.102.53
169.254.102.50
255.255.255.0