User manual

WI-MOD-9-E Wireless Ethernet User Manual
WI-MOD-9-E Manual V1.9 Page 56
Alternate procedure – Adjust WI-MOD-9-E network settings using serial
port(assuming configuration PC is on existing network)
a) Open terminal program with settings with data rate 19200bps, 8 data bits,
1 stop bit and no parity.
b) Set dipswitch to SETUP
c) Connect straight through serial cable to WI-MOD-9-E and power up unit.
d) When prompted, strike the Enter key to abort automatic boot
e) Set IP address of WI-MOD-9-E to 192.168.0.200 with command bip
192.168.0.200
f) Set netmask of WI-MOD-9-E to 192.168.0.200 with command bnm
255.255.255.0
g) Set gateway address of WI-MOD-9-E to 192.168.0.1 with command bgw
192.168.0.1
h) Set dipswitch to RUN
i) Reset WI-MOD-9-E with reset command.
j) Open configuration webpage with Internet Explorer at address
http://192.168.0.200/
When prompted for password, enter default username “user” and password
“user”
Enter “Quick Start”, and select Access Point.
IP address should be 192.168.0.200
Enter a System Generator String
Select the Radio Encryption required.
Save the changes.