User manual

WI-MOD-9-E Wireless Ethernet User Manual
WI-MOD-9-E Manual V1.9 Page 38
The routing rules for the Access Point in the above example are shown below. The first entry
shows the route to LAN B. The gateway for the route to LAN B is configured as the wireless IP
address of the WI-MOD-9-E client connected to LAN B. The destination for the route is
configured as the network address of LAN B. Because the host id of the destination IP address is
0, it specifies a network address. Consequently, any traffic received at the Access Point with
destination IP address 169.254.109.x (where x is any host id) will be forwarded to the WI-MOD-
9-E at LAN B.
The Routing Rules configuration page can be accessed by selecting the “Routing” link on any of
the configuration web pages. Up to 30 routing rules may be added to each WI-MOD-9-E. The
table below summarises the configurable parameters a routing rule.
Name A name to describe the routing rule (Max 32 characters).
Destination The destination network (or host) IP address (to specify a network
address set the host address to 0. i.e. for a class C IP address
192.168.0.0 would specify a destination network, while
192.168.0.16 specifies a destination host).
Gateway The IP address of the next-hop router for the specified destination.
Subnet Mask The subnet mask for the destination network.