User manual

WI-MOD-9-E Wireless Ethernet User Manual
WI-MOD-9-E Manual V1.9 Page 28
3.4 Quick Configuration
The WI-MOD-9-E has default configurations which will cover most applications. These
parameters can be manually changed however this is not necessary for the majority of
applications.
A “Quick Start” configuration is provided for simple networks. This is the first stage of the
module configuration. For most applications, no further configuration is required. For more
advanced applications, the other parameters can be changed via the other configuration pages
after the Quick Start page.
Enter the Configuration web-page as per section 3.3 and select “Quick Start”.
You need to select:
• Access Point or Client. Bridge operation is assumed - for Router selection, go to the
Network page after Quick Start
• IP Address and Subnet Mask for your application. The default settings will be shown. If your
system is connecting individual devices which are not connected to an existing Ethernet
LAN, then you can use the factory default IP values. If you are connecting to an existing
LAN, then you need to change the IP addresses to match your LAN addresses.
• A “System Generator String” - refer to section 3.4.1 below
• Radio encryption selection - None, 64-bit Proprietary or 128-bit AES - refer section 3.4.2
for more information on this.
After configuring, select “Save to Flash and Reset”.