User manual

Chapter Three Operation
Page 21 March 2010
3.2 Default Configuration
The default factory configuration of the WI-MOD-9-E is
• Bridge/Client
• IP address192.168.0.1XX, where XX is the last two digits of the serial number (the default
IP address is shown on the printed label on the back of the module)
• Subnet mask 255.255.255.0
• Username is “user” and the default password is “user”
The WI-MOD-9-E will temporarily load some factory-default settings if powered up with the
Factory Default switch (on the end-plate of the module) in SETUP position. In the position,
wireless operation is disabled. The previous configuration remains stored in memory and will
only change if a configuration parameter is modified and the change saved.
Do not forget to set the switch back to the RUN position and cycle power at the conclusion of
configuration for resumption of normal operation.