User manual

WI-MOD-9-E Wireless Ethernet User Manual
WI-MOD-9-E Manual V1.9 Page 10
There is limit of two Routers within the same radio network. There is no limit to the number of
Bridges in the same network - although there is a limit of 255 Client units linked to any one Access
Point.
1.2 Getting Started Quickly
Most applications for the WI-MOD-9-E require little configuration. The WI-MOD-9-E has many
sophisticated features, however if you don’t require these features, this section will allow you to
configure the units quickly.
First, read Section 2, “Installation”. The WI-MOD-9-E requires an antenna and a power supply.
 Power the WI-MOD-9-E and make an Ethernet connection to your PC (for further information on
how to do this, refer to section 3.3)
 Set the WI-MOD-9-E address settings as per section 3.4
 Save the configuration - the WI-MOD-9-E is now ready to use.
Before installing the WI-MOD-9-E, bench test the system. It is a lot easier to locate problems when
the equipment is all together.
There are other configuration setting which may or may not improve the operation of the system. For
detail on these settings, refer to section 3.