User manual

WI-MOD-E-100 & WI-MOD-E-300 Wireless Ethernet User Manual
WI-MOD-E Manual v1.10 Page 80
5. There are two options:
a. The “Save to Flash and Reset” button may be clicked, to initiate a reset
immediately after a successful firmware upgrade so that the new firmware is run.
b. Alternatively, Click “Save to Flash” button to just program the new firmware to
the unit. A reset is necessary to run the new firmware. This is useful for
maintaining radio link whilst performing upgrades to remote units.
6. The following dialog box may be displayed as a warning. Click OK to proceed.
7. Firmware upgrade will proceed, and should take about 1 minute if performed locally. If
performed over a radio link, the upgrade may take longer, depending upon the quality of
the radio link, and the amount of traffic on the network.
During the upgrade, the webpage shows a progress bar at the bottom right side of the
browser window.