User manual

WI-MOD-E-100 & WI-MOD-E-300 Wireless Ethernet User Manual
WI-MOD-E Manual v1.10 Page 26
e) Check values for Boot Address, Boot Netmask, and Boot Gateway. These values should be
setto reflect those of the PC you are using to configure the unit. If these are correct skip to step
(h). You may check settings again with the rct command. For further help, type the help
command.
f) Set Boot Netmask to the same settings as the computer you have the Ethernet cable connected
to. This may be performed with the command: bnm <Type the netmask>
g) Set Boot Gateway to the same settings as the computer you have the Ethernet cable connected
to. This may be performed with the command: bgw <Type the gateway IP address>
h) Choose an IP address for the WI-MOD-E being upgraded. This IP address must be on the same
network as the computer you have connected the Ethernet cable to. This may be performed with