User manual
WI-GTWY-9-xxx Wireless Gateway V1.18
68
The second example shows another I/O block
(registers 81 to 1080) that has been selected
for scaling only - the sensitivity function has
been disabled (these registers will use the
default sensitivity of 2000 configured on the
main Sensitivity configuration screen).
In this example, the full 16-bit range (0-
65535) is scaled to “signed 16-bit values”. A
value greater than 32767 (which will be seen
as a negative value) can’t be written to the
data bus.
In the last example, Scaling has been
disabled for register block 1100 – 1109.
Only sensitivity functionality is being used.
Note: If Scaling is not used at all, up to 50
blocks can be configured with different
sensitivity values. However is Scaling is
used, then only half this number of blocks is
available.