Installation guide

28 PV Clinics Installation Manual 21/07/11 01.00
3.14 Email Groups Screen
The Email Groups screen sets up the SMTP server settings. Communication with the SMTP server is as-
sumed to be via the computers internet connection and when an email is sent it will use the details given on
this page. For details of suitable settings contact your internet service provider (ISP) or your system adminis-
trator (to use your company’s mail server).
Note: Some ISPs will intercept traffic on port 25 so that you must use their mail server to relay messages.
SMTP Server and Firewall setup
Your company’s mail server will probably be set up to prevent relaying via port 25 unless specifically config-
ured. This is a matter for your System Administrator but most mail servers can be set up to relay messages
received from a specific IP address (the fixed IP address of your PV Plant) without problems.
Your company firewall must also be set to allow messages through from the PV Plant IP Address at port 25.
Sending a test email
Select an Email address and use the button (at the bottom of the screen) to test the
email settings. The logger will display messages showing progress.