Manualshelf

Installation guide

ManualsBrandsWeidmuller ManualsComputer equipmentSL-MOD-GW
11121314151617181920
www.weidmueller.com
3.3 Command line buttons
Copy, Paste, Insert and Delete buttons
To speed up the setup process you can use the Copy, Paste, Insert and Delete buttons at the bottom of
the screen whenever they are shown. These buttons let you build up a plant configuration by cutting and
pasting groups of custom devices, individual custom devices, custom device address maps, groups of string
boxes and individual string boxes.
Site/Table navigation buttons
The Arrows allow you to move up and down the rows a table and the Up button moves up the system tree
one level.
Disconnect buttons
These two buttons are only shown when the site is selected in the system tree. They allow you to save
changes and exit or to discard changes and exit.
Debugging/Test buttons
When the logger screen is shown there is a button to clear messages. When you are setting up a specific
email or SMS there are buttons to send test messages.
Icon Button Action
Copy
Copy the currently selected items to the clipboard
Paste
Paste clipboard items directly after the current selection
Insert
Insert a new (blank) line after the current selection
Delete
Delete the currently selected line
Save Save changes and exit site (Site level only)
Discard
Discard changes and exit site (Site level only)
Clear
Clears the messages in the logger screen
Arrows
Move to the top/previous/next/bottom row of a table
Up
Move up a level in the system tree
Test Email
Send a test email
Test SMS
Send a test SMS
3.4 Enable check boxes
All parts of the system have ‘enable’ check boxes. You will see these as you start to build the system. To
make commissioning easier, uncheck these boxes as you configure the system. Then you can enable each
part as you go through and test for correct operation before carrying on to the next group or device. If you
suspect that a device or communication link is not operating correctly you can leave it disabled until later.
‘Disabled’ parts are be marked with a cross in the System tree and ‘enabled’ parts are marked with a green
tick.