User manual

UMSLMODGW-1006 v
Important user information
This manual explains how to install, operate and configure a SL-MOD-GW. This device may only be used for
the applications described in this document.
This manual is to be used with a SL-MOD-GW with firmware version 1.6.
These instructions are intended for use by trained specialists in electrical installation and control and automation
engineering, who are familiar with the applicable national standards and safety procedures.
Safety Precautions
ELECTRICAL HAZARD
• This equipment must be installed and serviced only by qualified personnel. Such work
should be performed only after reading this entire set of instructions.
• Before performing visual inspections, tests, or maintenance on this equipment, disconnect
all sources of electric power. Assume that all circuits are live until they have been completely
de-energized, tested, and tagged. Pay particular attention to the design of the power
system. Consider all sources of power, including the possibility of backfeeding.
• Apply appropriate personal protective equipment and follow safe electrical practices.
• Turn off all power supplying the equipment in which the SL-MOD-GW is to be installed
before installing, wiring or removing the SL-MOD-GW.
• Always use a properly rated voltage sensing device to confirm that power is off.
• The successful operation of this equipment depends upon proper handling, installation, and
operation. Neglecting fundamental installation requirements may lead to personal injury as
well as damage to electrical equipment or other property.
Failure to follow these instructions could result in death or serious injury!