User Manual

Configuration
4-46
Debouncing time
The relevant input signal must have been present without
interruption for at least the set debouncing time for a message to be
triggered; shorter disturbances cannot trigger a message.
Text for High
A text that can be inserted into the message block using the text
block #VAL# or #DI1#...; thus, it is possible to modify the message
text dynamically, depending on the particular event.
Max. 16 characters.
Text for Low
A text that can be inserted into the message block using the text
block #VAL# or #DI1#...; thus, it is possible to modify the message
text dynamically, depending on the particular event.
Max. 16 characters.
Report
If you wish a message to be triggered via an input, it is imperative
that the appropriate input be set by ; .
Digital outputs
Switching time
The digital outputs can be switched by events (see Section 4.6
Alarm Message) "Switch if" and Section 4.9 Function control
"Switch if".
Switching time in seconds for which the output remains closed after
an event has occurred and before it reopens automatically
NOTE