User Manual
Description of Functions
3-20
3.3.2 Resetting to the factory defaults
If you wish to reset the IE-GPRS-I/O to a defined initial state, you can
load the factory settings:
• Turn off the IE-GPRS-I/O.
• Set the DIP switch to 1-1-0-0.
• Turn on the IE-GPRS-I/O.
• The LEDs 1 … 4 will flash yellow for 5 s.
• The LEDs 1 … 4 will go out one after the other.
• The status LED flashes red.
• The factory settings are now loaded.
• Turn off the IE-GPRS-I/O.
• Set the DIP switch to 1-0-0-0.
• Turn on the IE-GPRS-I/O; reparameterise the IE-GPRS-I/O if
necessary.
• Turn off the IE-GPRS-I/O.
• Set the DIP switch to 0-0-0-0.
• Turn on the IE-GPRS-I/O; the IE-GPRS-I/O is now ready for
operation.
Resetting the IE-GPRS-I/O to its factory settings will also reset the
password and the IP address!
Default factory settings
Default IP address: 192.168.1.120
User name: admin
Default password: 12345
NOTE