User Documentation

3. Configuring the device
3.1 Tools
A screwdriver with a 2.5-mm blade is required to set the device,
and to connect the conductors to the terminals.
3.2 Open the device
Remove the connector Press the lock lightly
on both sides of the housing to unlock it (1),
remove the upper part of the housing and the
electronics (2).
3.3 Settings
RS232 assignments (DTE/DCE), transmission speed, operating mode,
data direction control, and terminating resistors are set via the
DIP switches SW1 and SW2/SW3.
3.3.1 RS232/RS485/422 3.3.2 RS232/TTY
18
1
1
2
SW1
SW2
SW3
SW1
SW2
4292540000_IS_WAVEdata.qxd:429254_IS_WAVEdata.qxd 07.07.201