User Documentation

 76/20=:*<276

 9=285.6<

A screwdriver with a width of 2.5 mm is required to adjust the unit and to

connect the wires to the terminals.

 8.6260<1.=62<

Disconnect the plugs. Disengage the top part of

the housing by carefully pressing the latches on

both sides (1). Pull out the top part of the hou-

sing and the electronics section until they lock

(2).

 $.<<260;

Set input and output ranges, minimum input values

and measuring span via the DIP switches SW1 and

SW2.

Set the input range via the DIP switches

(no frequency generator required):

2 cases are to be distinguished:

1. below measurement frequency = 0 Hz

– Select operating mode "0...fmax". S2.3 = 0 and S2.4 = 0

– Set upper measurement frequency via the DIP switches

S1 and S2.1, S2.2 (see table).

– Ready!

2. Lower measurement frequency ≠ 0 Hz

– First, the lower measurement frequency has to be saved.

Select operating mode "save from fmin". S2.3 = 1 and S2.4 = 0

SW2

SW1