User Documentation

13
3. Mounting and Settings
3.1 Range adjustments
1. Remove

connector
2. Press locking clips

on both sides of the enclosure and pull out the
circuit board
3. Make required adjustments to the input range, hysteresis, frequency
and relay control using the DIP switches.
4. Replace connector after making adjustments
The connectors have been coded by the manufacturer, ensuring that
they cannot be reversed

.
5. If using the feed-through version, push through enclosing wire

Warning!!
The circuit board can only be inserted in one position.
3.2 Cross-connections for voltage supply

A maximum feed through of 2 A is possible
The cross-connectors have been coded by the manufacturer, preventing a
short circuit should the cross-connectors be reversed