User Documentation

3u-remote web server manual2112220000/05/01.2018
With the web server, the u-remote station is displayed on
a connected PC. This allows you to carry out the following
tasks e.g. for testing purposes, during commissioning or ser-
vice:
– Simulate the operation of the u-remote station
– Query the status of each coupler and module
– Display the parameters of couplers and modules, and
change them for testing purposes
– Access diagnostic information
– Safe the current configuration of a station and load a
saved configuration (UR20-FBC-MOD-TCP and
UR20-FBC-EIP only)
– Operate the station in force mode for testing purposes
1.1 About this documentation
The safety notices may contain the following warning sym-
bols:
Symbol Meaning
Warning against explosive atmospheres
Observe the documentation
Text next to this arrow are notes which are not rel-
evant to safety, but provide important information
about proper and effective work procedures.
▶ All instructions can be identified by the black triangle
next to the text.
– Lists are marked with a tick.
1.2 Complete documentation
This manual describes how to use the web server
application (Release 2.0 or higher). When us-
ing the u-remote station please also observe the
manuals “u-remote I/O-system” and “Modules for
Functional Safety”.
All documents are available to download from the
u-remote website.
1.3 General safety notice
WARNING
Explosion risk!
▶ Prior to starting work, make sure that
there is not a potentially explosive atmos-
phere!
WARNING
Manipulation of the control unit!
In Force mode, the system may be manipu-
lated to such an extent that can result in life-
threatening personal injury and damage to
materials.
Only use force mode if you are very familiar
with the connected system and know at all
times the consequences that your actions
will have!
ATTENTION
Risk of severe damage!
▶ Prior to connecting a PC, make sure that the u-remote
station has been earthed properly!
1 Introduction