User Documentation

Introduction
11
information must be integrated in the instruction manual for end users in the
specific national language by the mechanical engineer or the system
provider.
This documentation must be legible and available to the specified persons
and must be read and understood by them.
1.3.1 Contents of the document
Description of the:
● u-create studio user interface,
● Creation of projects using templates,
● Configuring devices
● Diagnostic options
1.3.2 Not included in this document
● Programming of control or operating devices,
● Configuration of panels or operating devices in the control,
● Working with additional tools for the control programming,
● Detailed description of the bus systems,
● Programming of C and C++ programs.
1.4 Additional documentation
The following documents are referenced several times below.
Designation Target group
Delivered System Manual
● Project engineer
● Electrician
● Programmer
● Start-up operator
● Service technician
For basic knowledge about the Ethernet-based fieldbus EtherCAT, we rec-
ommend the following sources:
● EtherCAT Technology Group (ETG): http://www.ethercat.org