User Documentation

Page 93

Error 3 - The entered activation code already has

been used either for registering another

Router or you have tried to register this

Router a second time.

A registration / activation code may be used only one time

for registering a Router. The activation code is used to

dedicate uniquely a physical Router to a configured u-link

Router object (u-link Device Management). In order to avoid

an un-controlled multiple use of the same activation code an

additional use has to be released before re-registering.

Appendix 1 – Registration of Router to u-link failed (How to solve)

u-link Web portal

Menu Device Management

Normally there are only 2 use cases for additional use of an activation code:

1. A defective u-link Router has to be replaced by a new device (manually

configured like the defective Router).

2. The configuration of an u-link Router was overwritten (eg. un-registered) or

a reset to factory defaults has been done.

How to release for additional use:

➢ Logon-on to the u-link Web portal.

➢ Open menu ‘Device Management’ and highlight the Router object.

➢ In section ‘Device Configuration’ click icon ‘Edit ‘ of parameter ‘Activation

code’.

➢ Then enable checkbox ‘Release for additional activation’.

➢ Now try again to register the Router.

Note: The checkbox only can be set if the status is ‘In Use’, a new not

assigned activation code displays the status ‘Not used’.

V1.5.1 / Oct, 2020

A1 - Router registration failed

Failure message 1 continued