User Documentation

Page 52

Updating the Router firmware to a u-link enabled version

(Step 4)

▪ Note: If you update an individually configured Router with an

older firmware version the stored configuration will not be

changed as long as if you not enable checkbox “Reset to

factory defaults”.

➢ Go to menu System → Software Update.

➢ Click button browse and select the firmware file (eg. IE-SR-

2GT-LAN_FN_3G_V3.1.0_Build_74521.bin).

➢ Click button ‘Start Update’.

▪ Wait around 2 minutes (until the PWR LED is no longer

blinking).

➢ Open the browser window again using the same IP address.

▪ In section ‘System data’ of menu ‘System state’ the new

current firmware version is displayed.

Displays the

current firmware

version after

update process

4.6 Configuration of the Router

Chapter 4 – Setup of a remote access scenario (Configuration Router)