User Documentation

Page 51

Connecting to the Router and open the Web interface (Step 3)

▪ We assume that the Routers configuration is set to factory default

values (LAN IP: 192.168.1.110, WAN IP: 192.168.2.110 or DHCP for 6-

Port models).

➢ Connect the PC to the Router LAN or WAN port (Here we use the LAN

port).

➢ Configure the PCs Ethernet interface to the same IP network range as

the Router (e.g. 192.168.1.99).

➢ Open a browser and enter IP address 192.168.1.110 to open the

Router Web interface.

➢ Enter user name admin and password Detmold.

▪ The home page (System state) will be displayed.

4.6 Configuration of the Router

Chapter 4 – Setup of a remote access scenario (Configuration Router)

Home page of Router

Web interface

Note about help tool “Weidmüller Router Search Utility”

The software Weidmüller Router-Search-Utility can be used to find Weidmüller Routers

and detect theirs IP addresses within a switched network. This software is very helpful if

you don’t know the current IP address of a Router. This e.g. can happen in cases that you

have forgotten the current IP configuration or if you have lost the router access in case of

configuring an unintended IP address. The main features of the software are

▪ Detecting a router and displaying the parameters IP address, subnet mask, MAC

address, serial number, device name, device location and firmware version

▪ Change the IP address of a detected router

▪ Open the web interface of a detected router

The software can be downloaded via this link

http://www.weidmueller.com/int/products/electronics-and-automation/industrial-

ethernet/software

➢ Goto section Industrial Security Router (Firmware and Software for IE-SR-2/6GT-

LAN/4G/LTE)

➢ Download entry Weidmüller Router Search Utility