User Documentation
2053260000/05/2015132
Installation
b) Fibre preparation and assembly taking the example of an
SC plug on a bre-optic glass bre cable with the fast-cure adhesive
(LC assembly is the same)
Shake the bottles of adhesive and activator before using for the rst time.
1 Prepare the cable in accordance with the
manufacturer's details.
2 Use the metering tip to apply activator
to the glass bres and around 5 mm of
secondary coating.
3 Press the adhesive into the rear of the plug
until it escapes from the hole on the plug
pin's face end.
4 Slide the bres back and forth in the plug
two or three times and then hold them
briey at the stop.
5
Spread the Kevlar braid evenly over the
plug body. Slide crimp sleeve on up to stop.
Crimp this with the crimping tool and cut off
the protruding Kevlar braid with the Kevlar
scissors.
6 Slide the anti-kink bushing forwards over
the crimp sleeve and up to the plug body.