User Documentation

6
Handling
Crimping tool
1. Place the contact in the appropriate wire cross-
section groove of the dies.
Close the crimp tool until the contact is firmly held in
position between the crimp dies.
Insert the wire into the contact.
2. Squeeze the handles together until the ratchet
disengages.
Remove the crimped wire and contact.
Additional notes
3. How to release the control cycle ratchet in the event
of an operating error.
Squeeze the handles lightly.
Using a screwdriver, force the retaining pawl
upwards and release the handles.
Field of application
The tool is designed for use in applications
described in the operating instructions only. Using
this tool for tasks other than those described may lead
to accidents or the destruction of the tool.
Maintenance
Subject to the frequency of use and type of service,
the tool must be checked regularly to ensure flawless
functioning. In the event that appropriate tests are not
possible on site, these can be conducted by the
manufacturer.
Repairs
The tool must only be repaired by an electro-
mechanical specialist or by the manufacturer, otherwise
operator accidents may result.
en