Document of Conformity

[13]

Schedule

[14]

TYPE EXAMINATION CERTIFICATE No.

DEMKO 17 ATEX 1904

Rev. 0

00-IC-F0060-1 – Issue 14.0

This certificate may only be reproduced in its entirety and without any change, schedule included.

Page 2 of 2

[15] Description of Product:

The passive Isolator PicoPak-CI-CO-LP series separates stand-analogue current signals. An analogue input current signal is converted

linear and galvanic isolated into an analogue output current signal. The power supply occurs through the input and output measuring circuit.

Intended to be installed in an industrial application within an end use enclosure.

Nomenclature for type PicoPak-CI-CO-LP series:

PicoPak- CI- CO- LP- x

I II III IV V

I PicoPak - PicoPak series

II CI – Current Input

III CO – Current Output

IV LP – Loop Powered

V S – Screw terminals

P – Push-in terminals

Temperature range:

The ambient temperature range is -40 C to +55…70 C.

Electrical data

18 to 32 Vdc, 50 mW supply

Input to isolator 6 to 35 Vdc, 4 to 20 mA.

Output to isolator 18 to 32 Vdc, 4 to 20 mA.

Routine tests

A dielectric strength routine test is required, as per the relevant industrial standards

[16] Descriptive Documents

The scheduled drawings are listed in the report no. provided under item no. [ 8 ] on page 1 of this Type Examination Certificate.

[17] Special Conditions of Use:

None

[18] Essential Health and Safety Requirements

The Essential Health and Safety Requirements (EHSRs) covered by the standards listed at item 9.

Additional information

The trademark will be used as the company identifier on the marking label.