User Documentation

Wi-Fi device IE-WL-VL-AP-BR-CL Web Console Configuration
3-46
Policy
Setting
Description
Factory Default
Accept
Only the packets fitting the entities on list can be allowed.
Drop
Drop
Any packet fitting the entities on list will be denied.
ATTENTION
Be careful when you enable the filter function:
Drop + “no entity on list is activated” = all packets are allowed
Accept + “no entity on list is activated” = all packets are denied
IP Protocol Filters
The IE-WL-VL-AP-BR-CL’s IP protocol filter is a policy-based filter that can allow or filter out IP-based packets
with specified IP protocol and source/destination IP addresses.
The IE-WL-VL-AP-BR-CL provides 32 entities for setting IP protocol and source/destination IP addresses in your
filtering policy. Four IP protocols are available: All, ICMP, TCP, and UDP. You must specify either the Source
IP or the Destination IP. By combining IP addresses and netmasks, you can specify a single IP address or a
range of IP addresses to accept or drop. For example, “IP address 192.168.1.1 and netmask 255.255.255.255”
refers to the sole IP address 192.168.1.1. “IP address 192.168.1.1 and netmask 255.255.255.0” refers to the
range of IP addresses from 192.168.1.1 to 192.168.1.255. Remember to check the Active check box for each
entity to activate the setting.
IP protocol filters
Setting
Description
Factory Default
Enable
Enables IP protocol filters
Disable
Disable
Disables IP protocol filters
Policy
Setting
Description
Factory Default
Accept
Only the packets fitting the entities on the list can be allowed
Drop
Drop
Any packet fitting the entities on the list will be denied
ATTENTION
Be careful when you enable the filter function:
Drop + “no entity on list is activated” = all packets are allowed.
Accept + “no entity on list is activated” = all packets are denied.