User Documentation

IE-WL-AP-BR-CL-ABG Web Console Configuration
3-20
Beacon Interval (for AP/Master mode only)
Setting Description Factory Default
Beacon Interval
(40 to 1000 ms)
Indicates the frequency interval of the beacon 100 (ms)
DTIM Interval (for AP/Master mode only)
Setting Description Factory Default
Data Beacon Rate
(1 to 15)
Indicates how often the IE-WL-AP-BR-CL-ABG sends out a
Delivery Traffic Indication Message
1
Fragmentation threshold
Setting Description Factory Default
Fragment Length
(256 to 2346)
Specifies the maximum size a data packet before splitting and
creating another new packet
2346
RTS threshold
Setting Description Factory Default
RTS/CTS Threshold
(256 to 2346)
Determines how large a packet can be before the Access Point
coordinates transmission and reception to ensure efficient
communication
2346
NOTE You can refer to the related glossaries in Chapter 5 for detailed information about the above-mentioned
settings. By setting these parameters properly, you can better tune the performance of your wireless network.
Transmission distance
Setting Description Factory Default
Distance or max. range
for transmission
(500 to 10000 m)
Specifies the transmission distance or max. range between two
IE-WL-AP-BR-CL-ABG devices. This parameter should be set
properly, especially for long-distance communication.
500
Noise protection
Setting Description Factory Default
Enable/Disable Adjusts the interference coping capability of the wireless signal.
This option should be enabled for communication distance
under 500 meters, and should be disabled for communication
distances over 500 meters.
Enable
Transmission enhancement
Setting Description Factory Default
Enable/Disable This setting can enhance communication by strengthening the
IE-WL-AP-BR-CL-ABG’s transmission power. It is quite useful
for long-distance transmission or countering environmental
interference. The user must carefully evaluate and measure the
transmission power of the entire system to ensure it stays
below the regulative limit. In addition, that RF type 802.11a
mode cannot be used if this function is enabled.
Disable
NOTE When Transmission enhancement is enabled, the Tx Power is at “Full”
RF type = B/G/Mixed (Channel1~13)
• US model: 22 dB
• EU model: 20 dB
RF type = A (Channel 36 ~ 48)
• US model: 17 dB
• EU model: 17 dB