Document of Conformity

ManualsBrandsWeidmueller ManualsAutomation & SoftwareIE-SW-VL09T-6TX-3SC

[13]

Schedule

[14]

TYPE EXAMINATION CERTIFICATE No.

DEMKO 11 ATEX 150188X

Rev. 4

00-IC-F0060-1 – Issue 14.0

This certificate may only be reproduced in its entirety and without any change, schedule included.

Page 2 of 2

[15] Description of Product:

The Models IE-SW-VL09-6TX-3SC and IE-SW-VL09T-6TX-3SC are DIN rail mounted, industrial application, Unmanaged Ethernet

Switches. They are intended for industrial applications, pollution degree 2 environments. They are microcomputer-based and communicate

via interfaces through wire. The models are of the open type and are intended for installation into a suitable enclosure.

The optical radiation output of the product with respect to explosion protection, according to Annex II clause 1.3.1 of the Directive

2014/34/EU is not covered in this certificate.

Temperature range:

The relation between ambient temperature and the assigned temperature class is as follows:

Ambient temperature range Temperature class

-40 °C to +75 °C

Electrical data

Model Construction

Version

Electrical Rating Relay Output

Models IE-SW-

VL09-6TX-3SC

and IE-SW-VL09T-

6TX-3SC

Ver. A 12-48Vdc, Max. 1.1A, Class 2 24Vdc, 1A, Resistive

Ver. B

12/24/48, 0.56/0.26/0.13A, Class 2 or

12-48Vdc, 0.56-0.26A, Class 2 or

12-48Vdc, 0.56A max. , Class 2 or

12Vdc, 0.56A , Class 2 or

24Vdc, 0.26A , Class 2 or

48Vdc, 0.13A, Class 2.

24Vdc, 1A, Resistive

Routine tests:

No routine tests were considered necessary.

[16] Descriptive Documents

The scheduled drawings are listed in the report no. provided under item no. [ 8 ] on page 1 of this Type Examination Certificate.

[17] Special Conditions of Use:

• The Ethernet Communication devices are to be mounted in a tool-accessible ATEX-Certified IP54 enclosure in accordance with

EN 60079-15, and used in an area of not more than pollution degree 2 as defined by EN 60664-1.

• Provisions shall be made either in the equipment or external to the equipment to provide the transient protection device to be set

at a level not exceeding 140% of the peak rated voltage.

[18] Essential Health and Safety Requirements

The Essential Health and Safety Requirements (EHSRs) covered by the standards listed at item 9

Additional information

The trademark will be used as the company identifier on the marking label.