Document of Conformity

ManualsBrandsWeidmueller ManualsAutomation & SoftwareIE-SW-VL08-8GT

[13]

Schedule

[14] TYPE EXAMINATION CERTIFICATE No.

DEMKO 11 ATEX 150194X Rev. 3

00-IC-F0060-1 – Issue 13.2

This certificate may only be reproduced in its entirety and without any change, schedule included. Page 2 of 2

[15] Description of Product:

Models IE-SW-VL08-8GT, IE-SW-VL08T-8GT, IE-SW-VL08-6GT-2GS and IE-SW-VL08T-6GT-2GS are open type Ethernet switches with

communication interface and are intended for use in industrial automation applications. They are microcomputer-based and communicate

via interfaces through wire. These devices are open-type devices intended for installation in an ultimate enclosure The subject Models

consist of two circuit boards and utilize Non-Sparking ”nA” and the Sealed Device ”nC” protection methods.

Model Differences -

IE-SW-VL08-8GT,IE-SW-VL08T-8GT

IE-SW-VL08-6GT-2GS, IE-SW-VL08T-6GT-2GS

Ethernet RJ45

Eight provided

Fiber

N/A

Two provided

Model IE-SW-VL08-8GT is identical to Model IE-SW-VL08T-8GT except for model designation. Model IE-SW-VL08-6GT-2GS is identical to

Model IE-SW-VL08T-6GT-2GS except for model designation. The difference between the Models is software related.

Models IE-SW-VL08-6GT-2GS and IE-SW-VL08T-6GT-2GS provide two fiber.

The optical radiation output of the productwith respect to explosion protection, according to Annex II clause 1.3.1 of the Directive

2014/34/EU is not covered in this certificate.

Temperature range:

The relation between ambient temperature and the assigned temperature class is as follows:

Ambient temperature range

Temperature class

-40 °C to +75 °C

-10 °C to +60°C (Alternate circuit board without suffix–T)

Electrical data

Model Nos.

Rated Supply Voltage and Current

Relay Contact Rating

IE-SW-VL08-8GT,

IE-SW-VL08T-8GT

12-48 V dc, Class 2, Maximum 0.8 A

24 V dc, 1 A, resistive load

IE-SW-VL08-6GT-2GS,

IE-SW-VL08T-6GT-2GS

12-48 V dc, Class 2, Maximum 0.9 A

Routine tests:

No routine tests necessary.

[16] Descriptive Documents

The scheduled drawings are listed in the report no. provided under item no. [ 8 ] on page 1 of this Type Examination Certificate.

[17] Special Conditions of Use:

• Subject devices are to be installed in an ATEX Certified enclosure rated not less than IP54 and accessible only by the use of a tool.

• Subject devices are for use in an area of not more than pollution degree 2 in accordance with EN 60664-1.

• Transient protection shall be provided to limit the peak rated voltage to maximum 140% of peak rated voltage

• When end users are providing optical SFP communication modules, this must be limited to laser Class 1 only.

[18] Essential Health and Safety Requirements

The Essential Health and Safety Requirements (EHSRs) covered by the standards listed at item 9

Additional information

The trademark will be used as the company identifier on the marking label.