User Documentation

User Manual Managed Switches
46
3.1.11 Restart
This function is used to restart the Ethernet Switch.
3.1.12 Factory Default
This function provides users with a quick way of restoring the Weidmüller switch’s configuration to
factory defaults. The function is available in the serial, Telnet, and web consoles.
NOTE: After restoring the factory default configuration, you will need to use the default
network settings to re-establish the web or Telnet console connection with the
Weidmüller switch.
3.1.13 Loop Protection
Avoid maintenance/installation crews from mistakenly placing one cable on the same switch
generating a loop problem.
Two ports that are looped will be blocked if the loop happens on the switch itself.
If triggered then the fault LED will light up.