User Documentation

User Manual Managed Switches
66
Coupling Control Port
Setting
Description
Factory Default
Coupling Control
Port
Select any port of the switch to be the coupling control
port
See the following
table
Below table lists the default coupling ports dependent on the used models.
Model
Default Coupling Port
Default Coupling Control Port
IE-SW-VL05M/08M Series
IE-SW-PL06M/08M/16M
Series
The fourth from the last port of the
Switch
The third from the last port
(highest port number) of the
Switch
IE-SW-PL09M Series
Port G7
Port G6
IE-SW-PL18M Series
Port 15
Port 16
IE-SW-PL10M Series
Port 7
Port G1
3.5.3.2 Configuring Turbo Ring V2 (new version)
1. Select Turbo Ring V2 in field Redundancy protocol.
2. If only a redundancy with 1 ring shall be created then do following:
 Activate checkbox ‘Enable Ring 1’
 Activate checkbox ‘Set as Master’ (for ring 1) if the switch shall be assigned as ring master
for ring 1
 Select the ‘Redundant ports’ which shall be used for ring 1
3. If the switch is used to connect 2 Turbo rings (Topology Dual-Ring) then additionally do following:
 Activate checkbox ‘Enable Ring 2’
 Activate checkbox ‘Set as Master’ (for ring 2) if the switch shall be assigned as ring master
for ring 2
 Select the ‘Redundant ports’ which shall be used for ring 2
4. Optionally enable ‘Ring Coupling’ and select coupling ports if a ring coupling topology shall be
used.