Approval/Certificate/Document of Conformity

[13] Schedule
[14] TYPE EXAMINATION CERTIFICATE No.
DEMKO 19 ATEX 2220X Rev. 0
00-IC-F0060-1 – Issue 15.1 This certificate may only be reproduced in its entirety and without any change, schedule included. Page 2 of 2
[15] Description of Product:
These devices are evaluated as open-type devices, microcomputer-based and communicate via interfaces through wire. They are intended
for installation into a tool-accessible only ultimate enclosure and can be installed by DIN-Rail mounting or wall mounting.
NOMENCLATURE:
IE-SW
-PL08M
-6TX
-2SC
I
II
III
IV
I – Basic type designation
IE-SW: Type designation
II - Total IO port configure
-PL08M: 8 Ports with ambient range -10 C to +60 C
-PL08MT: 8 Ports with ambient range -40 C to +75 C
III – total RJ45 ports
-8TX: 8 ports
-6TX: 6 ports
IV – Fiber connector type
-2SC: Subscriber Connector with Multiple mode port statues
-2ST: Straight Tip connector with Multiple mode port statues
-2SCS: Subscriber Connector with single mode port statues
The optical radiation output of the product with respect to explosion protection, according to Annex II clause 1.3.1 of the Directive
2014/34/EU is not covered in this certificate.
Temperature range:
-10 C ˂ Ta ˂ +60 C (For Model IE-SW-PL08M Series)
-40C ˂ Ta ˂ +75C (For For Model IE-SW-PL08MT Series)
Electrical data
Model
Electrical Rating
IE-SW-PL08M
series
12/24/48 VDC, 0.62/0.3/0.16 A, Relay output 24 VDC/1 A (Resistive), Class 2
Routine tests:
No routine tests are necessary.
[16] Descriptive Documents
The scheduled drawings are listed in the report no. provided under item no. [ 8 ] on page 1 of this Type Examination Certificate.
[17] Special Conditions of Use:
• The equipment shall only be used in an area of at least pollution degree 2, as defined in EN 60664-1.
• The equipment shall be installed in an enclosure that provides a minimum ingress protection of IP 54 in accordance with EN
60079-0.
[18] Essential Health and Safety Requirements
The Essential Health and Safety Requirements (EHSRs) covered by the standards listed at item 9.
Additional information
The trademark will be used as the company identifier on the marking label.