Document of Conformity

[13] Schedule

[14] TYPE EXAMINATION CERTIFICATE No.

DEMKO 16 ATEX 1727X Rev. 0

00-IC-F0060 – Issue 12.0 This certificate may only be reproduced in its entirety and without any change, schedule included. Page 2 of 2

[15] Description of Product:

Models IE-SW-BL05-4GT-1GS and IE-SW-BL05T-4GT-1GS are open type, programmable controllers with communication interface and

intended for use in industrial applications. They are microcomputer-based and communicate via interfaces through wire. These subject

devices are intended for installation into an ultimate enclosure that uses a tool removable cover/door.

The optical radiation output of the apparatus with respect to explosion protection, according to Annex II clause 1.3.1 of the Directive

2014/34/EU is not covered in this certificate.

Models IE-SW-BL05-4GT-1GS and IE-SW-BL05T-4GT-1GS have same constructions except for ambient temperature range.

Temperature range:

The relation between ambient temperature and the assigned temperature class is as follows:

Model

Ambient temperature range

Temperature class

IE-SW-BL05-4GT-1GS

-10 C to +60 C

IE-SW-BL05T-4GT-1GS

-40 C to +75 C

Electrical data:

Input: 12-48 V dc, 380 mA, Class 2

Relay Output: 24 V dc, 1 A, Resistance, Class 2.

Mounting instructions:

Devices can be either DIN-rail or wall mounted.

Routine tests:

No Routine Tests are necessary.

[16] Descriptive Documents

The scheduled drawings are listed in the report no. provided under item no. [ 8 ] on page 1 of this Type Examination Certificate.

[17] Special Conditions of Use:

 The equipment shall be installed in an enclosure that provides a degree of protection not less than IP 54 in accordance with EN

60079-15 and accessible only by the use of a tool.

 Devices are for use in an area of not more than pollution degree 2 in accordance with EN 60664-1.

 When end users are providing Optical SFP Communications modules, these must be limited to Laser Class 1 only.

[18] Essential Health and Safety Requirements

Met by compliance with the standards EN 60079-0:2012+A11:2013, EN 60079-15:2010.

The trademark will be used as the company identifier on the marking label.