User Documentation

Version 1.2 / August 2020 Page 66 / 102
Now the configured parameters will be activated (but not saved). After a few seconds the web interface dis-
plays the new IP addresses as shown below. Please keep in mind that you now have lost the Router connec-
tion due to changing the IP address range of your connected LAN port.
5. Change the IP address of the configuration PC according to the connected network 192.168.10.0 / 24
► To reconnect to the Router now set the IP address of the PC to the new values
IP address: 192.168.10.99
Subnet mask: 255.255.255.0
Standard-Gateway: 192.168.10.254
► Again login into the Web interface of the Router using a Web browser
Use IP address 192.168.10.254 (http://192.10.1.254) on LAN port
User: admin
Password: Detmold
6. Check the currently active “routes”
► Select menu Configuration → Network → IP routing → Tab “State”
7. Saving the new configuration
► Select menu System → Save or Click on the Disk icon in the upper left corner of the web interface
► Click on button “Save settings” to save the current configuration to the non-volatile flash memory of
the Router. If a SIM memory card is installed the configuration automatically will be stored on the
SIM memory card. Additionally, the configuration can be stored on the file system of the PC.
► Select menu System → Backup settings
► Click on button “Download settings” to write the configuration file to the PC hard disk (Backup file has
the default extension *.cf2”)
Currently active routing table